CAME STRAUSS GLO Manual página 4

Legend of symbols
EN
 This symbol shows parts which
must be carefully read.
⚠
This symbol means the parts which
describe safety issues.
Intended use
STRAUSS GLO is a radio-based weather
unit for commanding motors and
accessories fitted with radio receivers to
automatically manage mobile elements
(that is, boxed awnings, awnings, rolling
shutters, blinds) in relation to weather
conditions.
VERSIONS
STRAUSS GLO W : radio-based weather
unit with Wind sensor (item code
001YE0009).
STRAUSS GLO SW: radio-based weather
unit with Sun-Wind sensors (item code
001YE0010).
STRAUSS GLO SWR: radio-based
weather unit with Sun-Wind-Rain sensors
(item code 001YE0011).
 Any installation and use other than that
specified in this manual is forbidden.
119T70501 - ver. 1.0 - 10/2011
TECHNICAL DATA
STRAUSS GLO
Power supply 230 V AC 50/60 Hz
Frequency 433.92 MHz
Radio coding TTS
100 m outdoors -
Effective to
20 m indoors
Protection rating IP44
Working temperature -20°C / +55°C
Dimensions 131 x 269 x 164 mm
Power draw W 90 mA
Power draw SW 90 mA
Power draw SWR 110 mA
Weight 425 gr
STRAUSS GLO - WIND SENSOR
Sensitivity 1 km/h
Detection range / field 5/40 km/h
STRAUSS GLO - SUN SENSOR
Sensitivity 1 Klux
Detection range / field 15/60 Klux
STRAUSS GLO - RAIN SENSOR
Detection status ON - OFF
CABLE TYPE AND SECTION
Power supply to
Connection for
control panel
Cable type FR0R CEI 20-22 CEI
EN 50267-2-1
Cable length
1 < 10 m 2G x 0.75 mm
2
Cable length
2G x 1 mm
2
10 < 20 m
Cable length
2G x 1.5 mm
2
20 < 30 m
 If cables are of a different length than
that shown in the table, determine the
cable section based on the actual draw
and the number of connected devices and
according the what is set forth in the CEI
EN 60204-1 code of regulations.
DIMENSIONS
MAIN COMPONENT PARTS
1. Reset / test button
2. Programming button
3. Sun-adjusting trimmer
4. Wind-adjusting trimmer
5. Dip-switch
6. LED signal light
7. Sun-sensor terminals
8. Wind-sensor terminals
9. Rain-sensor terminals
10. Control panel terminals
11. Anemometer
12. Sun sensor
13. Rain sensor
⚠
Before acting on the device, cut off
the main power supply.
LED signal light
• power (green)
• transmission (TX) (yellow)
• test (red)
• sun warning (red)
• wind warning (red)
• rain warning (red)
Installation
⚠
Installation must be carried by skilled,
qualified technicians in accordance
with current regulations.
PRELIMINARY CHECKS
Make sure the control unit is fastened to
an impact-free areas, yet still in relation to
the chosen model, and that it is exposed
to air-flow, sun-light and rain-fall. Fasten
to solid, flat planes using proper bolts,
nuts and washers.
Set up proper conduits and electric
cable raceways, making sure these are
protected from any mechanical damage.
119T70501 - ver. 1.0 - 10/2011