Brixton KO-6383 Manual De Usuario página 5

GAS CYLINDER
• The gas cylinder should not be dropped or handled roughly! If the appliance
is not in use, the cylinder must be disconnected. Replace the protective cap
on the cylinder after disconnecting the cylinder from the appliance.
• Cylinders must be stored outdoors in an upright position and out
of the reach of children. The cylinder must never be stored where
temperatures can reach over 50
flames, pilot lights or other sources of ignition.
CHANGING THE GAS CYLINDER
Precautions need to be taken when changing gas cylinder, which shall be
carried out away from any source of ignition.
• Gas cylinders must be replaced in a flame free environment.
• Do not smoke while changing the gas cylinder.
• Turn off the gas cylinder valve or regulator fully (clockwise) and take the
empty cylinder of.
• Do not attempt to remove the regulator while the gas stove is still running.
• Make sure that the gas stove is extinguished completely.
• Remove the regulator from the empty cylinder.
CONNECTION TO APPLIANCE
• Before connection, ensure that there is no debris caught in the head of
the gas cylinder, regulator, burner and burner ports.
• Spiders and insects can nest within and clog the burner/venturi tube at
the orifice. A clogged burner can lead to a fire in the appliance. Clean
burner holes with a heavy-duty pipe cleaner
• The stove must be used in a well ventilated area. Do not obstruct the
flow of combustion air to the burner when the stove is in use.
• Only use this stove outdoors.
• Before use check for leaks.
o C. Do not store the cylinder near
IMPORTANT TEST FOR LEAKAGE
• Make 2-3 fluid ounces of leak detecting solution by mixing one part
washing up liquid with 3 parts water.
• Ensure the control valve is "OFF".
• Connect the regulator to the cylinder and ON/OFF valve to the burner,
ensure the connections are secure then turn ON the gas.
• Brush the soapy solution on to the hose and all joints. If bubbles appear
you have a leak, which must be rectified before use.
• Retest after fixing the fault.
• Turn OFF the gas at the cylinder after testing.
If leakage is detected and cannot be resolved. Do not attempt to repair
leakage but consult your gas dealer.
SETTING UP THE STOVE FOR USE
Open the lid
Instruction manual EN
5