Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this heater may result in property damage or personal injury.
CAUTION: Use gloves when handling glass rocks.
LAVAGLASS ASSEMBLY
Gently pour the Lavaglass into the tray around and
over the burner. The burner must be covered by
glass rocks completely. Otherwise the flame may
occasionally extinguish. Be careful not to cover the
ignition screen with the glass rocks. Keep the
ignition screen clear at all times. Always wear
gloves when handling lavaglass.
WARNING: DO NOT COVER THE IGNITION
SCREEN when placing the glass rocks into
the gas fireplace insert. Always keep Ignition
Screen visible. This screen must be clear and
free of obstructions at all times to insure proper
operation.
Ignition Screen
CORRECT
CAUTION: GLASS ROCKS - Use a glove when handling glass rocks.
1. Do not light or use gas unit if glass rocks are wet. Make sure glass rocks are
completely dry before lighting as intense heat could cause the rock to crack.
2. Glass rocks could hit a person's face or eyes during the initial startup of this unit.
Keep away from the appliance for the first 20 minutes after lighting.
3. Use only GHP Group Inc. factory-authorized glass rocks. The use of any glass rock
that is not factory-authorized can be dangerous and will void your warranty.
4. Do not add additional rocks to the gas fireplace insert. Only 9.9 lbs/4.49 kgs are
approved for safe use with this gas fireplace insert.
5. Do not use two different sizes of glass rocks at the same time.
6. Do not mix glass rocks with lava rocks.
Ignition Screen
INCORRECT
21
Lavaglass
(Glass Rocks)
Publicidad
