Livoo TEA306 Manual De Instrucciones página 7

Use of the device
Figure 3
Connect air hose to the Inflator. Screw the air hose to the tire valve
Turn on the power switch
Figure 4
Press "M" shortly to wake up the screen or start inflating
Press " " button to choose between the 4 different modes pre-stored in the device.
Long press " " button 3 seconds to change the pressure unit(bar, kPa, Kg/cm², PSI).
Figure 5
You can press "+" or"-" to increase or decrease target pressure before inflating.
Short press "M" to start inflating
When the real pressure reaches to the target pressure, it will stop automatically.
You can also stop inflating any time by pressing "M" Button.
Figure 6
1 Pressure display
2 Pressure unit
3 Increase preset pressure value
4 LED light switch
5 Model type
6 Battery display
7 Decrease preset pressure value
8 Change mode/change pressure unit
9 Wake up the digital display screen/Start inflating
Battery display (Figure 7)
First battery mark display: 100% > power > 70%.
Second battery mark display: 70% > power > 40%.
Third battery mark display: 40 > power > 10%.
Third battery mark display flashing: battery
power less than 10%, need to recharge.
To charge your device, use the supplied USB/Type-C cable. Connect the Type-C end of the cable to the
Type-C port on the device and the USB end to a port capable of charging your device. Be sure to
observe the charging voltage (5 V).
www.livoo.fr