Publicidad
Idiomas disponibles
Idiomas disponibles
not have a cross-section that
is smaller than those of rub-
ber hoses with the designation
H07RN8-F. The cable length
must total 10 m. The wire cross
section of the extension cable
must be at least 2.5 mm
• Protect mains cables and electri-
cal connections from moisture.
Make sure that mains connec-
tion cables and electrical con-
nections are located in a fl ood-
proof area.
• If the cord of this device is dam-
aged, it must be replaced by the
manufacturer or their customer
service or by a similarly quali-
fi ed person in order to avoid
hazards.
Operational start-up
Assembly
Fitting the lower aluminium pipe
1. Insert the large sealing ring (15) into
the adapter (11) of the pressure con-
nection.
2. Screw the adapter (11) to the pressure
connection (21) of the pump.
3. Clip the pipe holder (12) with the mid-
dle holder to the aluminium pipe. The
mounting rail of the pipe holder (12)
must point downwards.
4. Insert one of the two medium-sized
sealing rings (14) into the screw sleeve
(20).
5. Place an aluminium pipe (19)
onto the adapter (11) and
screw it with the screw sleeve
(20).
6. Push the pipe holder (12) onto the
aluminium pipe downwards until it en-
gages in the recess on the device.
Fitting the upper aluminium pipe
1. Connect the lower and upper
2
.
and each of the two screw sleeves
(18).
Fitting the plastic hook
1 Loosen the wing nut ( 8 ) on the plastic
hook ( 7 ).
2. Remove the screw ( 9 ) from the plastic
handle.
3. Clip the plastic hook ( 7 ) onto the upper
aluminium pipe ( 19 ).
4. Fix the plastic hook ( 7 ) with the screw
( 9 ) and wing nut ( 8 ).
Fitting the fl exible pipe
1. Insert the medium-sized sealing ring
( 14 ) into the screw sleeve (20) .
2. Push the fl exible pipe ( 17 ) onto the up-
per aluminium pipe ( 19 ) and screw it
with the screw sleeve (20).
Immersing the pump
• Use the plastic hook (7) or attach a
rope to the pump's carrying handle (2)
to immerse or raise the pump. Never
hang the unit directly from the
aluminium pipe (19) using
the connector (10). Place one
of the small sealing rings (13)
between the connector (10)
Be careful not to hold or
hang the unit by the mains
connection cable. There is a
risk of electric shock due to
damaged mains connection
cables.
When immersing the pump, make
sure that the shut-off valve(16) is
open to ensure that the pump is
vented.
GB
MT
23
Publicidad
