Max 10658 Manual De Instrucciones página 46

Use
Hold grinder in same way as a pen when
engraving, with air intake upwards. For large
jobs, hold in same way as a hammer. Always
keep ventilation slots clear.
Press the on/off button (8).
Select speed using speed selector (5).
Best results are achieved by not pressing
hard against item, but by keeping up
constant RPM. Use high RPM for small tools
and lower RPM for large tools. Use low RPM
for polishing and working wood and plastic.
Move grinder steadily and evenly.
Stop grinder immediately if tool gets stuck.
Disconnect from mains when grinder has
come to complete stop before disengaging
from item.
Switch off at mains when � nished with
grinder.
46
8
5
Recommended speeds
Task
Cutting metal
Grinding wood
Cutting hard materials
Engraving
Deburring
Drilling
Removing rust
Sharpening
Polishing
Selecting tool
Grinding stone
Used for sharpening, grinding, deburring or
removing rust from metal. Use the pro� le
best suited for the job.
Speed
5-6
5-6
5-6
4-5
4-5
4-5
3-4
3-4
1-2