Publicidad
EN
Hold the machine firmly with two hands at the same time
and do not loosen your grip before the machine stops.
Operate the machine in pairs if necessary.
10
MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
10.1
CLEAN THE MACHINE
Keep the machine and the motor free of leaves, branches or
excessive oil to prevent fire risks.
•
Use a moist cloth with a mild detergent to clean the
machine.
•
Clean all moisture with a soft dry cloth.
•
Use a small brush to clean the air vents.
11
STORE THE MACHINE
Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged components. If
it is necessary, replace the damaged components, tighten
screws and bolts, or speak to a person of an approved
service center.
4. Store the machine in a cool and dry location.
WARNING
CAUTION
CAUTION
WARNING
WARNING
NOTE
English
12
TROUBLESHOOTING
Problem
The motor does
not start when you
pull the trigger.
The machine
smokes during op-
eration.
The motor is on,
the bit do not
move.
There is too much
noise and/or vibra-
tion during opera-
tion.
13
TECHNICAL DATA
Voltage
No load speed
Bit
Torque
Weight (without battery
pack)
Battery model
10
Possible cause
Solution
Make sure that
The battery pack is
you tighlty install
not installed tight-
the battery pack in
ly.
the machine.
The battery pack is
Charge the battery
out of power.
pack.
1. Immediately
stop the ma-
chine.
The machine has
2. Remove the
damage.
battery pack.
3. Contact the
service center.
Do not use the ma-
The machine has
chine and contact
damage.
the service center.
Remove battery
The bit are
pack then clear
blocked.
blockage from the
bit.
1. Stop the ma-
chine.
2. Remove the
battery.
The parts are
3. Inspect for
loose.
damage.
4. Check and
tighten loose
parts.
Do not use the ma-
The parts have
chine and contact
damage.
the service center.
60 V
Forward: 210 min
-1
Reverse: 50 min
diameter: 8'' (200 mm)
length: 35'' (890 mm)
59 ft-lbs
33.5 lbs (15.2 kg)
60BA02, 60BA03, 60BA04,
60BA06, 60BA08, 60BA05,
60BA25 and other BAC ser-
ies
-1
Publicidad
