Publicidad
Idiomas disponibles
Idiomas disponibles
WArNING:
OPErATING INSTrUCTIONS BEFOrE USING THIS EQUIPMENT. Failure to follow all
instructions listed below may result in electric shock, fire and/or serious personal injury.
EXTENSION COrDS
Grounded tools require a three wire extension cord
use either a two or three wire extension cord. As the distance from the power supply outlet increases, you must
use a heavier gauge extension cord. using extension cords with inadequately sized wire causes a serious drop
in voltage, resulting in loss of power and possible tool damage. Refer to the table shown below to determine the
required minimum wire size.
The smaller the gauge number of the wire, the greater the capacity of the cord. for example: a 14-gauge cord
can carry a higher current than a 16-gauge cord. When using more than one extension cord to make up the
total length, be sure each cord contains at least the minimum wire size required. If you are using one extension
cord for more than one tool, add the nameplate amperes and use the sum to determine the required minimum
wire size.
Guidelines for Using Extension Cords
• If you are using an extension cord outdoors, be sure it is marked with the suffix "W-A" ("W" in Canada) to
indicate that it is acceptable for outdoor use.
• Be sure your extension cord is properly wired and in good electrical condition. Always replace a damaged
extension cord or have it repaired by a qualified person before using it.
• Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.
Recommended Minimum Wire Gauge for Extension Cords (120 Volt)
Nameplate
Extension Cord Length
Amperes
25 Feet
(At Full Load)
0–2.0
18
2.1–3.4
18
3.5–5.0
18
5.1–7.0
18
7.1–12.0
18
12.1–16.0
14
16.1–20.0
12
SPECIFIC SAFETY rULES FOr COrDLESS GArDEN
TrIMMErS
WArNING:
(GAINED FrOM rEPEATED USE) rEPLACE STrICT ADHErENCE TO PrODUCT
SAFETY rULES. If you use this tool unsafe or incorrectly, you can suffer serious
personal injury!
WArNING:
operation where cutting tools may contact hidden wiring or its own cord. Contact with a
"live" wire will make exposed metal parts of the tool "live" and shock the operator!
WArNING:
cut away from blades!
• Always wear safety glasses or goggles. Normal prescription eye or sunglasses are not safety
glasses.
• Always hold the tool firmly. Do not leave the tool running unless hand held.
• Check your work area for proper clearances before cutting. This will avoid cutting into
unintended objects.
• Do not try to grasp or remove trimmings when the tool is running. Only remove trimmings when
the tool is switched off and disconnected from the power supply.
• Before switching on the tool, be sure the blade is not contacting the cutting objects.
rEAD AND UNDErSTAND ALL WArNINGS, CAUTIONS AND
50 Feet
75 Feet
18
18
18
16
14
12
10
DO NOT LET COMFOrT Or FAMILIArITY WITH THE PrODUCT
Hold the tool by insulated gripping surfaces when performing an
Keep hands, loose clothing, and other objects not intended to be
100 Feet
18
18
18
16
16
14
14
12
12
10
10
10
8
8
.
Double insulated tools can
150 Feet
200 Feet
16
16
14
14
12
12
12
10
8
8
8
6
6
6
5
Publicidad
