Vector Active Series Side Panel - HH Vector VRM-110A Manual De Instrucciones

VECTOR ACTIVE SERIES SIDE PANEL

VECTOR ACTIVE SERIES SIDE PANEL
1. MAINS INLET IEC input for connection of an appropriate mains lead.
2. FUSE The main fuse is located at the top of the IEC socket. In case of failure replace only
with the type and rating specified on the panel.
3. MAINS SWITCH Turns the monitor on and off. Ensure the volume control is at
minimum when switching on and off.
4. VOLTAGE SELECT SWITCH This is factory set to the correct voltage for the region
the product is supplied to. If necessary it can be reset by removing the mains lead and then
loosening (but not removing) the screws securing the cover. The cover can then be pivoted
away from the switch which can be moved to select the alternate voltage. DO NOT
reconnect the mains lead until the cover is replaced and secured. Please ensure the correct
fuse is fitted (as printed on the panel) for the voltage being used.
5. EXTENSION SPEAKER OUTPUT This socket is provided to allow an 8Ω passive
monitor (such as the HH VRM-110, VRM-112 or VRM-115) to be connected, increasing the
volume and sound field on stage from your monitor rig. Connect using only good quality
cables with Neutrik Speakon plugs.
™
NOTE: This product is convection cooled. Do not cover the side panel.