Conel DR18VC0 Instrucciones De Funcionamiento Originales página 19

DR18VC0
LED light
When the Radio is on: press the LED button
(16), LED lights on with color change. The
rhythm of the flashing LED light is consistent
with the played music. Press the LED button
again, LED lights on with fixed color. Press the
LED button again, LED lights off.
Tuning (DAB)
When the device is first switched on in
DAB mode, the radio will auto scan to find
broadcast stations in the local area.
Briefly press the
10b) to scroll through the stations. Press
button to select.
Finding new stations (DAB) (FIG. M)
From time to time, new DAB radio stations may
become available. Or you may have moved to
a different part of the country. In this case you
may need to activate your radio to scan for new
stations. press the
perform a full scan of the DAB frequencies.
As new stations are found, the station counter
on the left side in the display will increase and
stations will be added to the list.
Manual tuning(FM): Briefly press the
button to set the desired frequency. Each
press will increase or decrease 0.05MHZ. The
frequency is shown in the display.
Scan Tuning (FM): Press the
button and hold for 3 seconds, the tuner
frequency will increase to seek the first radio
station with acceptable clarity and stop at that
station. The frequency is shown in the display.
The right arrow button may be pressed
again to continue seeking a radio station at
higher frequencies. The left arrow button
may be pressed to seek radio stations at
lower frequencies. The search function is only
available in FM mode.
Storing stations in preset memories
(DAB and FM) (FIG. N)
There are 5 memory presets for each
waveband.
Press and hold the desired Preset button (15)
until the preset number is shown on the display.
The station is then stored in the selected Preset
button.
or button (10a or
button. Your radio will
or
Repeat this procedure for the remaining presets.
Stations stored in the preset memories can
be overwritten by following the procedures
described above.
To recall stations from the preset memories,
briefly press the desired Preset button while
device is in radio mode. The preset number and
station frequency will appear in the display.
System reset (FIG. O)
Press the Clock button
10 seconds, press
the factory reset function interface. Then
press button to select 'Yes' and press
button to start the reset process. All
stored data in the device will be cleared and
restored to the original settings.
Maintenance and care
WARNING!
Before carrying out work of any kind (cleaning,
transport, storage), remove the battery from
the device.
CAUTION!
Never clean plastic parts with solvents or
other aggressive fluids. This could damage
or
the device.
Cleaning
Clean the device with a dry cloth or brush.
Repairs
Repairs must be carried out by an authorized
customer service centre only.
Spare parts and accessories
Other accessories can be found in the
manufacturer's catalogues. You can find
exploded drawings and spare part lists on our
homepage:
www.flex-tools.com/Disposal Information
EU countries only
Do not throw electric power tools into
the household waste! In accordance
with the European Directive 2012/19/
EU on Waste Electrical and Electronic
Equipment and transposition into
national law used electric power tools
must be collected separately and
recycled in an environmentally friendly
manner.
and hold on for
button to enter into
19