fanttik X8 APEX Manual De Instrucciones página 22

13. TROUBLESHOOTING
Problem
Slow inflation speed
Air compressor turns on but
does not inflate
Unable to increase or
decrease the preset
pressure
The inflator inflates normally
but the displayed pressure
is zero
Charging slowly
Solution
1. Check whether the air compressor's battery level is sufficient.
2. Check whether the air hose is leaking.
3. Check whether both ends of the air hose are securely connected.
4. Check whether the item that is being inflated is leaking
1. Check whether the air compressor's battery level is sufficient.
2. Check whether the pressure of the item being inflated exceeds the
preset pressure.
Make sure the air compressor is set to the correct mode. Manual
mode has a blank display without any icons and allows you to
adjust the preset value within the range of 3 - 150 psi.
The pressure of low-pressure inflatables including balloons is too
low to be measured.
Check if you are using a compliant 5V/3A charger and original
USB cable
- 18 -