Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT: DO NOT wash the snow blower with water. The
warranty will be voided if water is used on the snow blower.
IMPORTANT: When storing the snow blower or when it is
not being serviced, it is to remain in the upright position with
both wheels and auger housing on the ground.
NOTE: Refer to Battery Charger Operator's Manual for
information on storing your batteries.
4. Fold Handle.
Service
REPLACING THE AUGER DRIVE BELT
1. Ensure the snow blower is turned off and the safety key is
removed.
2. Remove battery(ies).
3. Remove the four hex washer screws (a) that secure the belt
cover (b) to the motor plate (Figure 19). Remove the belt
cover.
c
e
f
h
Figure 19
4. Using a needle nose pliers or spring puller, release tension on
idler pulley spring (c) and disconnect the idler pulley spring
from the idler pulley bracket (d).
5. Lift the idler pulley (e) and remove the belt (f).
6. Route the new auger belt around the drive pulley (g) and under the
idler pulley.
7. Route the end of the belt around the auger pulley (h).
8. Reconnect the idler pulley spring to the idler pulley bracket.
9. Reinstall the belt cover removed in Step 3.
PRODUCT CARE
d
g
b
a
REPLACING SHAVE PLATE
NOTE: The shave plate is attached to the bottom of the auger
housing and is subject to wear. It should be checked periodically.
1. Ensure the snow blower is turned off and the safety key is
removed.
2. Remove battery(ies).
3. Tip the snow blower back until it rests on the handles.
4. Remove the four star screws (a) securing the shave plate (b)
to the auger housing (c) (Figure 20).
NOTE: the two center star screws also secures the bottom shroud
to the auger housing.
5. Remove the existing shave plate.
6. Install the new shave plate.
7. Using the star four screws removed in STEP 4, secure the new
shave plate and bottom support plate to the auger housing.
b
c
Battery Disposal
THE RBRC® SEAL
The RBRC® (Rechargeable Battery
Recycling Corporation) Seal on the
nickel cadmium, nickel metal hydride
or lithium-ion batteries (or battery
packs) indicates that the costs to recycle
these batteries (or battery packs) at the end
of their useful life have already been paid by the manufacturer.
In some areas, it is illegal to place spent nickel cadmium, nickel
metal hydride or lithium-ion batteries in the trash or municipal
solid waste stream and the Call 2 Recycle® program provides an
environmentally conscious alternative.
Call 2 Recycle, Inc., in cooperation with the manufacturer and
other battery users, has established the program in the United
States and Canada to facilitate the collection of spent nickel
cadmium, nickel metal hydride or lithium-ion batteries. Help
protect our environment and conserve natural resources by
returning the spent nickel cadmium, nickel metal hydride or
lithium-ion batteries to an authorized service center or to your
local retailer for recycling. You may also contact your local
recycling center for information on where to drop off the spent
battery. RBRC® is a registered trademark of Call 2 Recycle, Inc.
17
a
Figure 20
Publicidad
