Publicidad
Idiomas disponibles
Idiomas disponibles
Height adjustment
Stand Fan
·
Insert the plug and play extension rod to
operate the fan as an stand fan.
Floor/Table Fan
·
Plug the head and connector of
the fan directly into its base to
use it as a floor/ table fan.
Fan Installation
·
Ensure that fan is not connected to any power source before
installation to guard against electric shock/ injury.
·
Please ensure that fan blade and front guard is secure before
use to guard against injury.
·
If not use, ensure that all wrapping and/ or cushioning
materials
(EPE foam/ plastic wrap etc.) are removed and properly stored operating fan.
1. Remove the blade lock nut, rear guard grill lock nut from the motor shaft pin.
Rear Guard Installation
1. Align each of the projections to the indents and fit the rear guard to the motor shaft.
2. Secure the rear guard with the Rear Guard Grill Lock.
·
The front guard and rear guard are packed with together with the fan blades in the same
bag. For ease, please separate the pieces before installation.
·
Kindly ensure that the rear gear is securely installed to avoid personal injury while in use.
In
s
Fan blade installation
1. Align the shaft pin on the motor shaft with the indents on the inner fan blade.
2. Tighten the blade lock nut.
·
The outer side of the fan blade must be facing outwards-
please ensure it is facing the right direction.
·
Ensure that the blade lock nut
is tightened firmly to avoid
noisy fan operations and/ or
personal injury.
Floor/ Table Fan Stand Fan
Rear Guard
Motor Shaft Housing
dent
Tighten blade lock nut
Blade Lock Nut
Projections
Twist the rear guard
grill lock to secure it
Indent
Inside of Fan blade
15
Warning: Be careful to not clip to your skin/ fresh.
Motor Shaft Pin
Rear Guard Grille Lock
Plugs on Shaft Pin
Publicidad
