Perel Tools WTL6 Manual Del Usuario página 3

5. Replacing the Lamp
1. Unplug the device and let the lamp cool down before replacing it.
2. Remove the 10 screws that hold the grille in place and gently remove the grille.
3. Carefully turn the defective lamp(s) to take them out of the starter. Remove the lamp(s).
4. Install the new lamp(s) (order code WTL6/SP1 or LAMP14) by connecting them to the starter.
5. Place the grille back and fasten its screws.
Caution: If the cover is damaged, disconnect the lamp immediately from the mains. Do not use the lamp with
a cracked or broken cover. Replace the cover immediately (order code VTLAMP6/SP1).
6. Technical Specifications
dimensions
colour
power supply
spare lamp
colour temperature
spare cover
ideal ambient temperature
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulting from (incorrect) use of this device.
For more info concerning this product and the latest version of this manual, please visit our website
www.perel.eu.
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this
manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
V. 02 – 30/04/2013
WTL6
arm length
lamp length
width
height
white
230 Vac
T5 14 W, order code WTL6/SP1 or LAMP14
6400 K
order code VTLAMP6/SP1
0 °C – 35 °C
3
105 cm
54.5 cm
60 cm
11 cm
©Velleman nv