Stadler Form Z-001 Manual De Instrucciones página 9

• See to it that the appliance is properly positioned to ensure a high stabil-
ity during its operation and make sure that no one can trip over the power
cord.
• The appliance is not splash-proof.
• For indoor use only.
• Do not store the appliance outdoors.
• Store the appliance in a dry place inaccessible to children (pack the ap-
pliance).
• If the power cord is damaged, it must be replaced by the manufacturer
or a repair shop authorized by the manufacturer or by similarly qualified
persons in order to avoid a hazard.
• Only use fragrances, aromas or essential oils that do NOT contain alcohol.
Alcohol can damage the appliance. Appliances that are damaged by such
additives are not covered by the warranty.
• Prior to any maintenance, cleaning and after each use, switch off the ap-
pliance and unplug the mains cable from the socket.
• Repairs to electrical appliances must only be carried out by a qualified
electrical technician.
• Only use the adapter provided by the manufacturer.
Setting up / operation
1. Place Zoe in the desired position on a flat surface. Connect the USB cable
(1) to the power adapter (2) and to the appliance (3) and insert the adapter
into a suitable socket. Alternatively, you can also connect the USB ca-
ble to another power source such as a PC or an external battery (battery
pack/power bank) with min. 2A.
2. Remove the lid (4) to fill with water and fragrance.
3. Fill the water container (5) up to the maximum mark (MAX) (6) with water.
No water may enter the air outlet opening (10). This will damage the ap-
pliance and will void any claim to the warranty. Important: please do not
carry Zoe around whilst it is filled with water. The water could run into
the electronics.
4. Add 2–3 drops of your favourite liquid fragrance directly into the water.
It is not necessary to mix them as the ultrasonic membrane (7) does this
for you.Only use fragrances, aromas or essential oils that do NOT contain
alcohol.
5. Close the lid (4) again.
6. Then switch Zoe on by pressing the on/off button (8). The LED in the cen-
tre of the top part will then start to glow. If this does not happen, check
whether there is sufficient water in the device or if the adapter is con-
nected to the electricity supply.
7. If you would like to top the water up, switch the device off and pull the
network plug out. Remove the lid and fill the water up to the maximum
mark.
8. If you are disturbed by the brightness of the illuminated mist (in the
bedroom, for example), you can reduce the brightness of the LEDs by
pressing the dimmer button (9). You can choose between three different
modes:
• Normal mode (switched on as standard)
• Dimmed mode (press once)
• Light-off mode (press twice)
You can return to normal mode by re-pressing the dimmer button (9).