practyl 18ID1-30.1A Instrucciones Originales página 87

WARNING :
- The vibration and noise emissions during actual use of the power tool can differ from the declared values depending
on the ways the tool is being used and especially on what kind of workpiece it is processed.
- There is the need to identify safety measures to protect the operator that are based on an estimation of exposure
in the actual conditions of use (taking account of all parts of the operating cycle such the times when the tool is
switched off and when it is running idle in addition to the trigger time).
Note:
-The declared vibration total value and the declared noise emission value have been measured in accordance with
a standard test method and may be used for comparing one tool with another.
- The declared vibration total value and the declared noise emission value may also be used in a preliminary
assessment of exposure.
- avoid vibration risk
Suggestion: 1) wear glove during operation
2) limit operating time and shorten trigger time
OPERATION
WARNING : The device should be disconnected from the mains before putting into operation
BIT INSTALLATION
When selecting a drill bit, use the right type for your job. For best performance, always use a sharp drill bit.
1. To open the chuck jaws, hold its collar while turning the sleeve in the counter clockwise direction. Insert the
drill bit deeply into the chuck, and then center the bit in the chuck jaws.
2. To close the chuck jaws, hold the collar while turning the sleeve in the clockwise direction.Tighten securely.
3. Remove the drill bit in reverse order.
NOTE: The chucks of reversible drills are always fixed by a screw with a left hand thread. The screw must be loosed
before the chuck can be removed if necessary. To loosen the screw, turn it in a clockwise direction.
FORWARD / REVERSE ADJUSTMENT
1. For forward (clockwise) rotation, push the forward /reverse switch to the left position.
2. For reverse (counterclockwise) rotation, push the forward/reverse switch to the right position. Although an
interlock prevents reversing the tool while the motor is running, allow it to come to a full stop before reversing.
WARNING: If the forward / reverse switch is in the central position, the tool can not be switched on.
SELECTING THE IMPACT / DRILL MODE
The impact/drill switch should be set according to the type of action required. The tool has two settings:
- Drill mode : For drilling into wood and metal. Use standard drill bits.
- Impact mode : For drilling into stone and masonry. Use masonry drill bits.
VARIABLE SPEED TRIGGER SWITCH
WARNING: Always check that the power supply is the same as that indicated on the nameplate of the tool.
This tool has a variable speed switch which can reach higher speed with increased trigger pressure. Speed
is controlled by the pressure to the switch trigger. The variable speed feature is particularly useful when starting
drilling. It also enables you to select the best speed for a particular application.
To limit the maximum speed of the tool, rotate the dial on the front of the trigger until the desired setting is achieved.
Turn the dial to the"+" direction to increase the speed and to the "-" direction to decrease the speed.
NOTE: It is recommended to use the variable speed feature for a short time only. Do not continuously operate the tool
at different speeds. It may damage the switch.
LED WORKLIGHT
The tool has a LED light to illuminate the work area and improve vision when working in areas with insufficient
lights.
The LED light will switch on automatically while the trigger switch is depressed
EN - 87