EDIFIER W210BT Manual

Wirel e s s Ne c kba n d H ea d p ho n e s
EN 1. Power ON/OFF
Indicator
2. Pairing
1. When they're power off, press and hold the power button for 5s.
Green and red LED will blink rapidly.
2. Select "EDIFIER W210BT" in your device setting to connect.
1st Pairing
1. Once the headphones are power on, they will enter Bluetooth
pairing automatically. Green and red LED will blink rapidly.
2. Select "EDIFIER W210BT" in your device setting to connect.
Note:
For subsequent use, the headphones will auto-connect to device
used last time.
3. Reset
1. The headphones are power on and disconnected from all devices.
2. Press and hold the " " and "v" at the same time for 5s.
3. The status light blinks green until reset is completed.
4. Once the headphones are reset, they enter pairing mode
automatically.
4. Controls
x1
x1
Note:
1. : Press and hold
2. Images are for illustrative purposes only and may differ from the
actual product.
For more information, please visit our website:
@Edifierglobal
Model: EDF200104
Edifier International Limited
P.O. Box 6264
General Post Office
Hong Kong
www.edifier.com
2023 Edifier International Limited. All rights reserved.
Printed in China
NOTICE:
For the need of technical improvement and system upgrade,
information contained herein may be subject to change from time
to time without prior notice.
Products of EDIFIER will be customized for different applications.
Pictures and illustrations shown on this manual may be slightly
different from actual product. If any difference is found, the actual
product prevails.
W 21 0B T
Manual
Press and hold the power button for 3s.
3s
www.edifier.com
@Edifier_Global
5s
5s
3s
x1
x3
x2
@Edifier_Global
5s
x1
x1
x2