ECOPOSTURAL C3566 Instrucciones página 15

English
Pay special attention in the case of children and/or unauthorized personnel. Do not
leave children alone or unattended in the area around the stretcher.
Maintenance or cleaning tasks must be carried out only by authorized personnel and
with the stretcher drive systems properly blocked.
For adjusting the height use the foot pedal. Press the foot control switch pedal: left downwards / right
upwards.
Attention: When adjusting the height, the stretcher makes a horizontal displacement of about 20 cm from
its initial position. This requires a space that facilitates maneuverability during the process of adjusting the
height of the stretcher. Take care during the process to avoid entrapment between the stretcher and the
wall or adjacent objects.
d) SECTIONS adjustment
The head-/backrest section is operated by a gas spring (3)
The central section is operated by a gas spring (3)
The feet section is operated by knob/lever (1)
The feet section being detachable simply pull out the pull tabs at both sides of the section to release the
fastener. Then pull out the section completely. Next, release the leather strips by detaching the Velcro
under the seat.
In order to place the feet section back on proceed in the reverse order. Pull out the pull tabs and slide the
fasteners through the holes at both sides of the section. Next release the fasteners to lock. Finally join
together the leather strips under the seat.
(1) Knob/Lever: With one hand, loosen the knob or lever to release the bar. With the other hand, position
the section at the required tilting. Release the knob or lever and the section will lock itself.
(3) Gas spring: Press the mechanism situated at the very edge of the section towards the upholstery and
the table section will go up slowly. Release mechanism to lock position. To lower the section, press the
mechanism with one hand and with the other hand, push the section downwards to the required position.
NEVER adjust any of the table sections WHILE THE PATIENT IS LEANING ON.
Safely position your FINGERS AND HANDS AWAY from the upholstery edge to avoid any
accidental jamming.
e) ACCESORIES Adjustment
How to adjust the articulated LEG SUPPORTS.
To adjust the height of the leg support, loose the black push-button lever to unlock the bar and move it up
or downwards to attain the required height or simply pull the bar out completely. Screw back on the lever to
lock.
To adjust the tilting of the leg support, loose the black lever under the support upholstery to unlock the
swivel plate. Next incline the leg support to the required position and screw back on the lever to lock.
* By pressing the push button of the lever you will be able to move the lever freely, no need to screw or
loose. This push button turns out to be very useful when the turning angle of the plastic levers is limited
due the short distance to the table frame.
3) MAINTENANCE
For safety reasons, DISCONNECT THE TABLE from the electrical supply before the table
cleaning, repair or servicing.
a) Metal FRAME
For a proper operation of the chair, you should do the dusting regularly with a cloth.
Periodically check visually for any signs of damage and make sure that all bolts, nuts and other fasteners
are tight.
* Please note that the repeated exposure of the table to high levels of humidity is not recommended.
15