Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION GUIDE AND USER'S MANUAL
This solar shower is intended for external use, near a swimming pool, on a beach
or in a garden. Before using your new solar shower, please read the recommenda-
tions and the user's manual.
CAUTION
During the hottest days of summer, it is possible that the temperature of the water contained
in the tank exceeds 60 °C. Before taking a shower, mix the water, put the mixer on "cold
water" and then adjust the temperature progressively until obtaining a pleasant temperature.
Do not touch the surface of the shower in order to avoid any risk of superficial burns.
It is possible that water continues to run after turning off the shower. This is normal and it stops
within the following 10–15 seconds.
Do not use the shower in case of storms, in order to avoid any risks of lightning.
The solar shower is designed to be used under "normal" water supply conditions, with a pressure
lower than 3 bars (3 kg). Otherwise provide a pressure reducer.
INSTALLATION
1.
Choose a location well exposed to direct sunlight (ideally to 360°) near a water supply and
drainage. The support must be solid (concrete floor, slab, tiled floor, wooden deck, heavy
wooden grating, anti moisture treated).
2.
Drill the bracket in front of the shower attach-
ment holes. Four holes approximately 12 mm
in diameter and of 70 mm of depth, using the
base of the shower as a reference. The drilling
templates are available on www.formidra.fr
3.
Insert the dowels and fix the solar shower ver-
tically using a spirit level, correct the verticality
with washers if necessary.
4.
Assemble the showerhead with the joints provi-
ded, install the shower head fastening it on the
shower body.
5.
Jolly Go model only: assemble the foot rinse
and the shower holder by screwing it onto the
body of the shower. Make sure to put the seal
between the 2 parts.
(If the seal is not sufficient, add a strip of Teflon
around the male thread.)
Solar shower
4
INSTALLATION GUIDE AND USER'S MANUAL
Publicidad
