Zone UME Manual De Instrucciones página 5

4. Gently twist the top to separate it from the ceramic part and fill with soap/
hand sanitiser. Please make sure that the silicone ring and mouth of the
ceramic part are dry before re-attaching the top.
5. After filling: Activate the pump by placing your hand under the spout several
times until soap/hand sanitiser comes out. To refill, simply repeat the
process.
6. Hold your hand 2 cm from the spout of the dispenser.
NOTE:
1. Do not shake the sensor as this may damage the technical parts.
2. Remove the batteries if the sensor is not going to be used for some
time.
3. The sensor withstands splashes of water, but do not place in
shower etc.
4. The dispenser can be used at temperatures of 3-40°C.
Do not place in direct sunlight for extended periods of time.
5. Always hold on to the ceramic base when lifting the dispenser.
6. If no soap is dispensed, even after several attempts, turn the
dispenser off by gently pressing the button. Then turn on again to
reset the sensor.
3. Press the button on top of the dispenser to
activate the sensor. A brief light signal indicates
that the sensor is activated.
The sensor function is sensitive. To disable it,
touch the button and hold (for about 8 seconds).