Assembly Instructions Headligth Protector
3. Install the support
(4) on the upper le�
side of the chassis.
Use the original
motorcycle Screws
and plas�c caps (11)
E
4
11
F
11
5. Install the Le� Side
Crashbar on the
Mastech Kit Supports
already installed on
the motorcycle.
Use Screws (6) for
the Points as shown
in the diagram (I-J)
6. At this point, the
alignment Steel
Spacer (13) must be
installed at point
(M) to install the
crashbars on both
6
sides with kit
Screws (6).
Install the Right
Crashbar on the
Mastech Kit
Supports already
installed on the
motorcycle, use
Screws (6) for Points
as shown in the
diagram (K-L-M).
After the installation of the parts, please check that they are aligned and that all the hardware is properly tightened
Calle 76 # 52D - 74 / Telefax: (57+4) 448 8428 / Medellín - Colombia
F
E
I
6
J
J
6
6
K
M
6
L
6
www.mastechno.com
4. Install the support
(5) on the lower le�
side of the chassis.
Use the hardware (7)
and (12) as well as the
(10) for the other
assemble point.
G
7
12
H
5
10
K
L
BMW 750/850 GS
H
G
I
J
J
M