Publicidad
Idiomas disponibles
Idiomas disponibles
3.8.11 Press "Function Key" to enter the next setting and directly go to the
Double-effect health model "
indicates the current state, 0-off, 1-open, and press "TEMP+" "TEMP-" key to
adjust the setting parameters.
3.8.12 Press "Function Key" to enter the next setting and directly go to the
Ultraviolet sterilization mode "
indicates the current state, 0-off, 1-open, and press "TEMP+" "TEMP-" key to
adjust the setting parameters.
3.8.13 Press "Function Key" to enter the next setting and directly go to the
reserved items.
3.8.14 In this case, the line controller is the entry for the function setting.
Press and hold the "Query" key on the 3.8.1 interface to enter the user parame-
ter setting interface.
In the user parameters interface, the right digital tube displays the serial
number of the setting item, and the middle digital tube displays the numerical
value, as shown in the table below. In the user parameter interface: press the
"Fan +" , "Fan -" key or function key to select the serial number of the setting
item; press "TEMP+" "TEMP-" key to adjust the parameter value.
Serial
Parameter
number
Fahrenheit/
1
Celsius setting
Set the maximum
2
temperature
Set the minimum
3
temperature
Temperature
4
display in the
main interface
select prompt tone
5
of press key
Cleaning
reminder time
6
setting
Remote master
7
/slave settings
Multiple online
8
address settings
Constant air flow
9
setting
" will flash. The "Big double 8 digital tube"
" will flash. The "Big double 8 digital tube"
Parameter Description
Default ℃; ℃->℉->℃
Default 32℃,with range of 24-45℃
Default 88℉, with range of 76℉-88℉
Default 16℃,with range of 5-24℃
Default 61℉, with range of 61℉-76℉
Display set temperature by default
(display indoor temperature)
0: voiced(Default) 1: silent
2000h/3000h/3500h/4000h
/ 5000h/6000h (Default 4000h)
Default 0-host; 1- slave(optional)
0~99
0: OFF(Default)
1: ON
07
Remarks
Displayed at set temperature
Display set value
Display set value
Display 0/1
Display 0/1
Display 20/30/35/40/50/60
(This option can only be set when
two line controllers are connected,
otherwise normal communication
will not be realized)
Display set value
Only valid for constant air flow
ducted units
V.1
Publicidad
