Philips S6640 Manual página 29

Cleaning the beard styler attachment
10 Reinsert the hinge of the shaving head holder
into the slot of the shaving unit. Close the
shaving head holder.
Clean the beard styler attachment after each use.
1 Pull the comb off the beard styler attachment.
Note: Grab the comb in the center to pull it off
the beard styler attachment. Do not pull at the
sides of the comb.
2 Rinse cut hairs off the cutting unit with
lukewarm water.
3 Rinse cut hairs off the comb.
4 Remove the cutting unit from the beard styler
attachment. By pushing the cutting unit off the
beard styler attachment, you can remove any
hairs that have accumulated inside the beard
styler. You can also rinse the bottom of the
cutting unit.
5 Rinse cut hairs out of the beard styler
attachment.
6 Carefully shake off excess water and let the
comb, cutting unit and beard styler attachment
air-dry before you use them again.
29
English