Removing The Surface-Mounted Belt Winder (E.g. In The Event Of A Move) - Superrollo GW60 Instrucciones De Montaje

i
20. Removing the surface-mounted belt winder (e.g. in the event of a move)
1.
Delete all settings.
2.
Fully close the roller shutters.
Press and hold the button.
3.
In doing so, pull the belt as far as
possible upwards out of the belt
winder.
Risk of injury due to the winding
wheel.
Never touch the winding wheel
compartment when the drive is in
operation. Remove the mains plug
before touching the winding wheel
compartment.
4.
Remove the power supply from the
socket, open the operating panel
and release the belt from the fix-
ing hook.
Pull it out completely.
5.
Subsequently release the belt win-
der from the wall bracket.
6.
Finally release both connectors
from the back of the device with a
small screwdriver and dismantle
the solar sensor.
+ +
EN
93