i-tec U3CHARGEHUB13 Manual De Instrucciones página 5

Quick Start / USB 3.0 Charging HUB 13 Port EN
INTRODUCTION
The HUB is an ideal companion for everybody who does not have enough USB
ports in his/her notebook, ultrabook or PC and who has to constantly connect and
disconnect his/her favorite USB equipment such as flash disks, mobile phones,
tablets, digital cameras, MP3 players, printers, etc.
This HUB offers 13 USB 3.0 ports with the Plug & Play function and standard
USB charging – the HUB will automatically detect connected equipment for USB
charging. As this HUB is equipped with 13 USB 3.0 ports, it can charge up to 13
devices at a time. The USB 3.0 interface is especially important for data transfers
from USB 3.0 memory cards and flash drives, where its high transfer rate is
most used. In the packing is included also an external power adapter, which is
essential for the HUB. The power adapter guarantees the USB charging stability
and HUB performance.
This HUB does not require installation of drivers. You will just connect it by the
USB cable to your computer and immediately you can start using it. This HUB has
a built in overcurrent protection of your computer in case of short connection on
the peripheries. The interface is compatible with USB 2.0 / 1.1.
INSTALLATION IN WINDOWS 7 / 8 / 8.1 / 10, MACOS X 10.6 AND HIGHER,
LINUX, CHROME OS
The HUB is installed automatically, no need install drivers. Connect the connec-
tor of the power adaptor to the HUB and connect the power adaptor to a socket
outlet with 230V. Then plug the HUB via USB cable into available USB port (USB
3.0, 2.0 or 1.1 standard) of your notebook / PC and follow the on­screen instruc-
tions. The HUB will be installed and displayed in Device manager as "Generic USB
Hub" and "Generic USB SuperSpeed Hub".
1
3
5
2
4
5