Schou 82066 Manual De Instrucciones página 3

REMOTE CONTROL FUNCTIONS
Button Function
Power on/off
Adjust the speed of the LED colour change
,
Use the mode -/+ buttons to choose the LED mode (multiple
modes to choose from)
,
Adjust the brightness of the LEDS
,
Press once to auto play multiple kinds of effects. Long press 5
seconds to enter the colourfull RGB jump effect and start the
LED strip test.
Single cycle: In automatic playback mode, press the "SET"
button once, then press the "lock" button to capture the current
effect loop. To "unlock" the selected mode, press "auto" button
or "mode" button.
To adjust the number of LED pixel points and the RGB or-
der: Long press 5 seconds to enter the setup menu and press
"MODE +" and "MODE -" to adjust the number of LED pixel
points. It adjusts 32 points each time. Press "SET" to save the
settings.
Remote control ID matching: Long press 5 seconds to match
remote control to the chair. (LED strip will flash green 3 times),
long press again 5 seconds to cancel the match (LED strip will
flash white 3 times)
White static monochrome mode
W
Red static monochrome mode
R
Green static monochrome mode
G
Blue static monochrome mode
B
Yellow static monochrome mode
Y
Cyan static monochrome mode
C
Purple static monochrome mode
P
3
EN