Makita DBN500 Manual De Instrucciones página 9

Driving nails
CAUTION:
• Always be sure to first place the contact element
against the workpiece before pulling the trigger.
Select the nailing mode by pressing the mode select-
ing button as mentioned in the section "Nailing mode
selection".
Intermittent nailing (sequential mode)
2
1
► 1. Place the contact element against workpiece.
2. Pull the trigger
To drive a nail, set the lock button to the "FREE" posi-
tion. Place the contact element against the workpiece
and pull the trigger. Release the trigger after each
operation.
Continuous/ intermittent nailing
(continuous mode)
1
2
► 1. Pull the trigger 2. Place the contact element
against workpiece.
When the tool is set to continuous mode, you can oper-
ate either continuous or intermittent nailing.
To drive a nail, set the lock button to the "FREE"
position.
— For continuous nailing, pull the trigger first and
then place the contact element against the work-
piece. For the next actuation, you do not need to
release the trigger.
— For intermittent nailing, place the contact element
against the workpiece and pull the trigger. For the
next actuation, you need to reset the trigger first.
NOTE:
• This tool stops automatically under the following
conditions:
— If you release the trigger or contact element from
workpiece before the tool finishes the operation
completely.
In this situation, pull the trigger again until the tool
turns into standby.
— When keep either pulling the trigger or placing the con-
tact element about 5 seconds without another action.
In this case, release the trigger or the contact
element from workpiece to restart the operation.
Anti dry fire mechanism
This tool is equipped with an anti dry fire mechanism.
It automatically stops driving nails when the remaining
nails finish. In this case, load more nails to resume
operation.
Removing jammed nails
WARNING:
• Always make sure that the trigger is released,
and the battery cartridge and nails are removed
before removing jammed nails.
1
3
2
► 1. Hex bolt A 2. Hex bolt B 3. Hex bolt C 4. Driver
guide cover
Remove hex bolts they are securing the driver guide
cover with the hex wrench.
Take the jammed nails from the nail guide groove that
has appeared.
Secure the driver guide cover with hex bolts in the cor-
rect order. Tighten the hex bolt A, B and then C.
NOTE:
• After securing the driver guide cover, always
make sure that the driver guide cover actuates
properly. If it does not actuate properly, remove
hex bolts and install the driver guide cover
again.
Nails
Handle nails and their box carefully. If the nails have
been handled roughly, they may be out of shape or their
connector breaks, causing poor nail feed.
Avoid storing nails in a very humid or hot place or place
exposed to direct sunlight.
9 ENGLISH
4