AON BUSINESS HS-100 Guía De Usuario página 3

Correct usage of barcode scanner：
(1) Make sure barcode scanner, cable, host device
connect properly;
(2) Press trigger button and the red laser line appears,
and move the laser line to cover barcodes completely,
adjust barcode scanner's distance and angle to figure
out best reading status ;
(3) Do not scan the setting barcodes in the manual
without instruction, it may cause barcode scanner not
work properly;
(4) Avoid 90 degree to read barcodes.
1D Laser
Barcode Scanner
User Manual
HS-100 1D Wired Scanner
Structure Chart：
Interface
Insert paper clip into the socket and press to remove
device cable
Interface
trigger
Version
Press trigger to remove device cable
Product feature：
(1) Support to read 1D standard barcodes such as
EAN13, industrial 2 of 5, UPC etc;
(2) Fast and accurate reading ,max to 150scans/sec;
(3) Eco and affordable item whch with stable performance;
(4) Plug and play ,easy to use.
Technical Parameter：
Data Item
Light Sources
Correct Reading Correct Reading
Supported
Symbologies
Resolution
Incorrect Reading Incorrect Reading
Scan Type
Scan Speed
Scan Mode
Paper Clip Socket
Scan Mode
Depth of
scan field
Interface
Error Rate
Cable Length
Material
Current
Voltage
Drop/Shock
Resistance
Operating
Temperature
Storage
Temperature
Relative
Humidity
Basic configuration
Note: Factory Default interface is USB-HID
Barcode scanner Setup instruction
Eg: add suffix "CR"
Performance Parameters
650nm(Safe visible laser diode)
Step 1: Scan "Factory Default"
UPC-A, UPC-E, EAN-13, EAN-8,
Codabar, Code 39, Code 39 Full ASCII,
China Post, Plessey, MSI, Code 93,
Code 128, Industrial 2 of 5, Interleave 2
of 5, Matrix 2 of 5, Code 11, ISBN, ISSN,
Code 32(Italian pharm code), Code 39
extended, GS1-128 and ITF-14, SISAS,
GS1 Omnidirectional, GS1 Limited,
Aviation 25, RSS 14.
≥3mil
Single Laser
≥150 times/s
Interface
Manual/Continuous/Automatic scanning
Yaw 65°,Rotation 30°,Pitch 55°
10-280mm(0.33mm, PCS90%)
USB-HID, USB-COM, PS2, RS232
Less than 1/5 million
2M
ABS+PC
85 mA
DC 5V±1%
With stands multiple times 3 meters drops to concrete
-20℃ - 50℃
-40℃- 70℃
5% - 95% RH(Non-condensing)
Interface notes:
(1) USB-HID Mode: Factory default mode, automatically
identify and install driver;
Factory Default
(2) RS232 Mode: Require special customized Rs232
cable and designated serial port APP;
(Default parameters: Baud Rate 9600 Data Bit: 8bits
Stop Bit:1bit Check Bit: None)
(3) USB-COM, Required to install special driver (Claim it
from distributor);
(4) PS2 Mode: It need to reboot the device to activate
barcode scanner.
Scan Mode
Step 2: Scan "CR"
USB-HID
Auto-sense Mode
(default)
USB-COM
PS2
Buzzer
RS 232
Munual(default)
Continuous
Auto-Flashing
Enable
Disable
OFF