Switching On/Off; Volume / Tips - Loc8tor tabcat Manual Del Usuario

SWITCHING ON / OFF
ON
• Hold in the right hand side button (see Button Guide) for 2 seconds.
• The Handset will then bleep and all the lights flash.
• Small status light will flash whilst on.
• The Handset will automatically power down after 45 seconds if left idle.
OFF
• Hold in the right hand side button for 2 seconds. Tabcat will beep and turn off.
VOLUME
Press in the left hand side button to select from three volume settings; Off, Low or High.
An audio beep will sound when pressed indicating the current volume level.
TIPS
• If a locate button is pressed with no Tag assigned to it an error tone will sound and the status lights will
blink rapidly. To register a Tag to this button, complete the steps 'REGISTER A TAG'.
• When inserting a battery inside the Tag, you must listen to the amount of beeps the Tag emits. If it beeps
once – It's registered, if it beeps twice – It's unregistered. If there are no beeps – the battery is flat or hasn't
been put in correctly.
• Range will vary depending on location and environment. Locating from a high vantage point could help
improve your range. Training your cat to come home using Tabcat could help to avoid a lengthy search.
• If you can't pick up your cats signal, try going out of your cat's normal territory. It can also be worth riding
or driving in car while searching to cover more ground.
6
www.mytabcat.com