Wagan Tech Power Dome 200 Manual De Usuario página 5

Power Dome 200 by Wagan Tech
TM
• Reconnect and observe the LED
• If the LED is green, turn ON the Jumper Safety switch
9. Inside the vehicle, turn on the ignition switch and attempt to start the engine.
10. Crank a maximum of three seconds. If the engine does not start, wait three minutes
before the next attempt
11. After the engine starts, turn OFF the Jumper Safety switch.
12. Disconnect the black clamp first, and then disconnect the red clamp.
13. Be sure that the cables and clamps are securely stored.
14. Recharge the Power Dome as soon as convenient.
NOTE: If the engine does not start, there may be a problem other than a discharged
battery. Call for service.
USB Power Port
Set On/Off safety switch to the "USB port" position. The USB Power Port is located underneath
the charging jack. It can power/charge devices that require 5 Volts up
to 500mA through the use of a user-supplied cord.
Extending Run Time
Extending the run time of Power Dome's inverter or compressor can be accomplished by
powering these functions from a charged external 12 volt automotive-type battery.
1. Follow the procedure for jumpstarting an engine as far as connecting the cables
checking for correct battery polarity and turning on the Cable Switch.
2. Now the compressor or inverter can operate for an extended time
• The low voltage protection feature will shut off the inverter when the external
and internal batteries discharge to 10 volts.
• The compressor does not have a low battery shut-down feature so the
user must check the Battery Status meter on the Power Dome.
3. After The Power Dome is used in an extended run time configuration, turn off the
compressor or inverter.
www.wagan.com
7
User's Manual—Read before using this equipment
4. Turn off the Cable Switch and store the cables and clamps
5. Recharge the Power Dome and external battery as soon as possible
Trouble Shooting Guide (for inverter)
Trouble Cause
Lack of power Power Dome battery
output voltage below 10 volts
Excessive current
drawn by appliance
being operated
Inverter fuse blown
Inverter Power Excessive voltage drop
Indicator is not lit.
Inverter is overloaded
Television/Power High surge wattage
Tool will not start requirement to start-up
Television Picture breaking up
Interference (snow).
© 2010 Wagan Corporation.
All Rights Reserved.
Wagan and wagan.com are trademarks used by Wagan Corporation.
Remedy
Recharge the Power Dome immediately
Reduce load to maximum of 200 watts
1. Turn OFF the device and inverter
2. Disconnect device
3. Turn the inverter ON and run for
a minimum of 2 minutes
4. Turn OFF inverter, quickly plug
in device to inverter making sure
device is OFF prior to connection
5. Turn ON the inverter and device
Check and replace if necessary. Be sure
any replacement fuse is the same type
and rating.
Check Power Dome and recharge if
voltage drops below 10 volts.
Reduce load to maximum of 200 watts.
Toggle the On/Off switch in quick
succession five times. If the device does
not start, the device is not compatible with
this type of inverter.
Place the Power Dome as far from the TV,
antenna, and coaxial cable as possible.
TV station may be out or range.
Do not use inverter with low quality audio
AC filtering system.
8