Publicidad
Idiomas disponibles
Idiomas disponibles
EN
This manual contains important information that should be kept
for future reference.
Self-assembly.
Warning! Keep children away from the assembly area. Leave the
plastic bags out their reach. The small parts pose a choking hazard.
Materials
Drawer, sliding door: medium density fibreboard (MDF) paint oak
veneer.
Cross bar: rubberwood veneer oak.
Legs: paint solid oak.
Assembly Instructions
Before starting the assembly, identify all components using the
manual.
In order not to misplace components, do not discard the packaging
until complete assembly is completed.
This product must be mounted by an adult.
Plan to assemble the furniture as close to the installation location
as possible.
Mount on a clean, level surface.
Recommendations for use
This product has been designed for indoor use only. Do not stand
on the product.
Do not sit on the product.
Do not climb the shelves.
Do not overload the shelves.
Beware of sharp objects.
Wood-based products, particle board, painted, varnished and
/ or lacquered, may give off an odor when opened. This smell
disappears after a few weeks if the room is properly ventilated.
Maintenance
Dust regularly with a dry cloth.
Clean with a soft, damp cloth. Then wipe with a clean, dry cloth.
Sponge up spilled liquids immediately with a clean, dry, dabbing
cloth to absorb the liquid.
In order not to damage the surface, it is recommended not to
deposit a hot or humid object directly on it.
Do not use magazines or newspapers as a trivet. The ink used
may leave traces that can permanently stain the surface of the
furniture.
To avoid scratches, do not use a recurring sponge or grain
detergent.
To avoid the appearance of marks, do not leave any object immobile
for more than 2 months.
Do not place the product near a heat source (radiator, chimney,
etc.) or a source of moisture. Heat and moisture can cause cracks
and deformations.
The use of special products for furniture is not recommended or
even necessary. Clean the veneer with a soft, damp cloth. Then
wipe with a dry cloth.
Do not use abrasive products.
Maintain with movements in the direction of the wood fibers.
Keep the label with lot number, it may be useful in case
BC
of complaint.
If you have any comments or suggestions regarding this product,
assembly instructions or service received, please enquire at your
nearest store or contact us on our website at: www.habitat-design.
com or write to this address: HABITAT, 70 AVENUE VICTOR HUGO,
93300 AUBERVILLIERS FRANCE.
Stan - 01/2023
The packaging elements are to be sorted out according to local
requirements. Make the right sorting choice and give them a
second life!
By sorting out this manual you contribute in preserving
the environment. This manual can still be found on
www.habitat-design.com.
2
Publicidad
