Descargar Imprimir esta página

AMS AM MINI WIRELESS Manual Del Usuario página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

13. USB/BT interface: This interface includes a display with state and track information, buttons for
PLAY-PAUSE/REW/FF and MODE selector.
USB slot: Insert a USB pendrive with audio tracks. Use the buttons |<<, >>| to navigate between
them and press play when you find the desired track.
14. PHONES output: Connect a headphones to monitor the mix.
15. POWER Switch: Push down to switch on the mixer and push up to switch off the mixer.
INSTALLATION
CONVENTIONAL MIXER OPERATION
You can connect the external power supply or the USB cable to a PC. In both cases, this connection is
ONLY FOR SUPPLY PURPOSES.
-
USB MP3: Insert a USB pendrive with audio files in MP3 format and press the PLAY ">||" button,
Use the buttons "|<<, >>|" to navigate between the audio tracks.
-
Bluetooth: Press MODE button until you see "BLUE" in the display. Check in your smartphone the
device name: ASHLEY and link it.
-
REC Mode: Insert a USB pendrive, press Mode button until you see "REC", then push PLAY ">||"
and counter the counter will start running indicating the seconds of recording. To end the
recording, long press the PLAY button.
WIRELESS MICROPHONES OPERATION
Be sure to insert batteries in the wireless microphones unscrewing the bottom part of the wireless
microphones where the battery compartment is located, always respecting the polarity of the batteries.
Turn on the microphone by turning the switch to the ON position. The mixer will indicate with a steady
green LED light that the signal from microphone A, B or both are being received.
Adjust the high, Low, and Level for these two microphones with the single channel control.
SOUND CARD OPERATION
- You can connect with a USB type A to type A cable to a PC. This connection WILL SUPPLY THE MIXER
and ACT AS INTERFACE.
- It will appear "PC" in mixers's display.
You can select in the setup menu of your computer this mixer named "JieLi BR2" as an input device,
output device or both, depending on the configuration you need.
4

Publicidad

loading