Descargar Imprimir esta página

V7 UPS3000RM2U Manual Del Usuario página 4

Ups 3000va - para instalación en bastidor - 2 unidades
Ocultar thumbs Ver también para UPS3000RM2U:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 44
1.4 Setup
1. UPS input connection
Plug the UPS into a grounded receptacle only. Avoid using extension cords, power strips or surge protectors
2. UPS output connection
There are two kinds of outputs: programmable outlets and general outlets. Please connect non-critical devices to the
programmable outlets and critical devices to the general outlets. You may extend the backup time to critical devices by
setting shorter backup time for non-critical devices
3. Communication connection (Optional)
USB Port
To allow for unattended UPS shutdown/start-up and status monitoring, connect the included USB cable from the
computer to the UPS system
Note: USB port and RS-232 port can't work at the same time.
4. Network connection
Network/Fax/Phone surge port
Connect a single modem/phone/fax/network line into surge-protected "IN" outlet on the back panel of the UPS unit.
Connect from "OUT" outlet to the equipment with another modem/fax/phone/network line cable.
5. Disable and enable EPO function
This UPS is equipped with EPO function. Pin 1 and Pin2 are closed by default for normal UPS operation.
Note: The EPO function logic can be set up via LCD setting. Please refer to program 16 in UPS setting for the details
Method 1
Remove two top screws
Method 2
Remove two front screws
Pull out metal pin
Pull out the entire green connector

Publicidad

loading

Este manual también es adecuado para:

Ups1rm2u3000-1e