HTC VIVE XR 2QBB100 Guía De Seguridad página 6

Prevention of hearing loss
CAUTION:
Permanent hearing loss may occur if product's headset is used at high volume for prolonged periods of time.
This device has been tested to comply with the Sound Pressure Level requirement laid down in the applicable EN 50332-1 and/or EN 50332-2 standards.
About Headset regulatory agency identifications
For regulatory identification purposes, VIVE headset product is assigned a model number of 2QBB100. Headset FCC ID is NM82QBB100. For more Regulatory information and compliance marks (E-labels), please refer to your device via the following steps:
Settings > About > Regulatory Information
To ensure continued reliable and safe operation of headset, use only the following accessory with your 2QBB100:
- Battery Pack with a model number of B2Q7Y100.
NOTE: This product is intended for use with a certified Class 2 Limited Power Source, Rated 5 Volts DC, 3 Amp; 9 Volts DC, 2 Amp; 12 Volts DC, 1.5 Amp power supply unit.
LASER WARNING
Class 1 Laser product:
This product complies with international standards IEC 60825-1:2014 and EN 60825-1:2014/A11:2021, Class 1 laser product, EN 50689:2021, Class 1 consumer laser product, and also complies with 21 CFR 1040.10 and 1040.11 except for conforma nce with IEC 60825-1
Ed. 3., as described in Laser Notice No. 56, dated May 8, 2019.
Caution: Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. This product contains Class 3B laser, which can produce hazardous level of Class 3B and 4 laser radiations. However, the
design of this product incorporates optics, a protective housing and a scanning safeguard such that there is no access to levels of laser radiation above Class 1. Under no circumstances should this device be operated with the housing removed. Only trained factory personnel
should open the protective housing.
Caution: Avoid prolonged direct eye and/or skin contact with the laser aperture. May result in potential burn injury.
About Controller regulatory agency identifications (Optional)
For regulatory identification purposes, VIVE controller product is assigned a model number of 2Q8R100 / 2Q8R200. Controller FCC ID is NM82Q8R100 / NM82Q8R200. This FCC/IC ID can also be found on the controller itself.
To ensure continued reliable and safe operation of your controller, use only the following accessory with your 2Q8R100 / 2Q8R200:
Battery Pack with a model number of B0PLH100.
NOTE: This product is intended for use with a certified Class 2 Limited Power Source, rated 5 Volts DC, 1 Amp power supply unit.
5