Publicidad
Idiomas disponibles
Idiomas disponibles
3. Select the input mode by pressing the source button located on the right-side
panel.
4. Using the controls on the remote, you can manage and select your tracks,
increase, or lower the volume, mute the sound bar audio, etc.
VI. Advanced operation
Pairing the sound bar with your Bluetooth
Note: Before installing this product, please make sure your device is compatible
with Bluetooth
.
®
1. First, turn on the soundbar by pressing the power button on the side panel or
on the remote control. Bluetooth
®
can also select the BT mode by pressing the mode selection button in the
remote control. The BT indication will appear on the LED display.
2. Place both devices not more than three feet away from each other.
3. Enable the Bluetooth
function on your audio device and set it to discover the
®
wireless soundbar.
4. The BT icon will start blinking to indicate that the system has entered into
pairing mode.
5. Once the soundbar appears listed under the newly found Bluetooth
(KSB-00A), the pairing process will start.
6. If pairing is successful, a tone will be heard.
7. If after 60 seconds the pairing process fails, please repeat steps 1 through 6
described above.
device
®
(BT) is the selected mode by default. You
devices
®
Troubleshooting
Problem
Suggested solution
The unit is not turning on.
Make sure the power cord is connected correctly to
the power source.
There is no sound coming
Make sure the audio cable is connected correctly. Turn
from the soundbar, or the
up the volume slowly. Press the mute button in case it
sound is distorted.
was pressed accidentally muting the soundbar.
The remote control
Install two AAA batteries in the remote. Replace the
doesn't work.
current batteries with new ones. Point the remote
control toward the front of the soundbar and make
sure it is within the operating range.
The buttons on the
Unplug the soundbar, plug it to a power supply and
soundbar don't work.
turn it on again.
Publicidad
