Oursson JM7002 Manual De Instrucciones página 19

• At the beginning of juicing, the pulp can be wet.
• The recovered pulp can be wet if you are using stale ingredients.
Pulp is very wet
• Before juicing ingredients stored in the refrigerator for a long time, put them in clean drink-
ing water for 1-2 hours .
Cup vibration • A small vibration of juice cup is allowed during operation. It is not considered a malfunction.
• Make sure the amount of fruit and vegetables is not too large and the motor is not over-
The device loaded.
has stopped • Make sure all the large seeds were removed from the fruit.
working • Turn off the device and switch it on REV (Reverse) mode for 2-3 seconds. Turn on the
device again.
Cup's lid
• When juicing finishes, switch the device on REV (reverse) mode for 2-5 seconds for easier
doesn't open
disassembly and use more power to rotate the lid counterclockwise.
properly
During the
• First, turn the device off by placing the key switch to the neutral position. Then turn the key
operation of
to down position REV and hold for 2-3 seconds. to remove the ingredients that are blocking
the device the
the pressure screw. After that, turn on the device. In case this does not work, unplug the
pressure screw
device, disassemble and clean it.
stops abruptly
Specifications
Model
Power consumption, W
Rated voltage
Protection class
Storage and transportation temperature requirements*
Operation temperature requirements
Humidity requirements
Dimensions (H×W×L), mm
Weight, kg
*Products should be stored in dry, ventilated warehouses at temperatures below - 25°C.
PRODUCT CERTIFICATION
For information on product certification, see http://www.oursson.com or ask seller for a copy.
Only a qualified specialist of an authorized service center OURSSON AG can repair the juice maker.
JM7002
max 240
220-240 V~; 50-60 Hz
I
-25 °C to +35 °C
+5 °C to +35 °C
15-75%
480×240×210
7,3
19