Casselin CCB3 Manual Del Usuario página 15

5. INSTALLATION AND USE
5.1 Safety instructions
ELECTRICAL HAZARD
Danger from electric current!
• No contact with heat sources should take place with the power cord.
• Cord should not hang over edge of table or counter.
• Do not pour water into an appliance that is in operation or that is still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
In operation, the device can reach high temperatures. To avoid burns and accidents, do not use the device
in malfunction, and do not use spare parts that are not original.
ELECTRICAL HAZARD
Danger from electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The appliance must be unpacked
and checked completely before connection by a professional.
5.2 Use
WARNING
The set-up of the device installation and maintenance must be carried out by professionals only.
• Do not leave the appliance running without supervising it.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
MANUAL
INSTALLATION
Take the brick heater out of the packaging and place the appliance on a flat, smooth surface. Peel off the
plastic covering from the device.
If this appliance is placed near a wall, partition, kitchen cabinet, decoration, etc., they should be coated with
a suitable non-flammable coating or protective material. combustible thermal insulation and that the power
supply be accorded to fire prevention regulations.
Once the device has been set up by consulting international standards and regulations.
The brick heater is ready to operate.
SURGERY
Fill the water tank to the level indicated.
Plug in the device and turn it on, turn the temperature knob clockwise to the desired setting, the element
starts heating up and the green light is on.
An operating parameter is in position 5 (approximately 65 to 80 degrees).
When not in use, all you need to do is turn off the temperature button, turn off and unplug the unit.
SECURITY
Do not overfill the water pan, the unit has been installed with a thermal cutout to prevent overheating or
damage to the elements.
If the power cord is damaged, it must be replaced by a qualified technician.
Tout le matériel CHR disponible sur notre site en cliquant ICI ou sur le logo et profitez des meilleurs offres et des meilleurs garanties
Tél: 09 71 04 20 23
Cliquez ici pour découvrir tout nos produits CHR
Cliquez ici pour le catalogue produits Casselin
Email: info@stock-direct-chr.com
EN