Descargar Imprimir esta página

Kobalt KMS 1040-03 Manual Del Usuario página 17

Accesorio para
Ocultar thumbs Ver también para KMS 1040-03:

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
WARNING:
• Release trigger switch (B) in the OFF position and remove the battery before performing
troubleshooting procedures.
PROBLEM
Tool does not
work.
String trimmer
stops while
cutting.
Trimmer head
will not advance
the cutting line.
WARRANTY
For 5 years from the date of purchase, this product is warranted for the original purchaser to
be free from defects in material and workmanship. This guarantee does not cover damage
due to abuse, normal wear, improper maintenance, neglect, unauthorized repair/alteration, or
expendable parts and accessories expected to become unusable after a reasonable period of
use. This warranty is limited to 90 days for commercial and rental use.
If you think your product meets the above guarantee criteria, please return it to the place of
purchase with valid proof of purchase and the defective product will be repaired or replaced at
no charge. This guarantee gives you specific legal rights, and you may also have other rights
that vary from state to state.
POSSIBLE CAUSE
1. Low battery pack capacity.
2. The battery pack is not
attached to the power head.
1. The motor shaft or trimmer
head is bound with grass.
2. The motor is overloaded.
3. The battery pack or string
trimmer is too hot.
4. The guard is not mounted
on the trimmer, resulting in
an overly long cutting line
and overload.
1. The trimmer head is bound
with grass.
2. There is not enough line
on the spool.
CORRECTIVE ACTION
1. Charge the battery pack.
2. Attach the battery pack to the power
head.
1. Stop the trimmer, remove the battery
pack, and remove the grass from the
motor shaft and trimmer head.
2. Move the trimmer head to cut the
grass no more than 8 in. (20 cm) of
length in a single cut. Remove the
trimmer head from the grass and restart
the tool.
3. Release the trigger switch, wait for
the tool to cool down, and then start the
tool again.
4. Remove the battery pack and mount
the guard on the trimmer.
1. Stop the trimmer, remove the battery
pack, and clean the trimmer head.
2. Remove the battery pack and replace
the cutting line by following the section
"Line Replacement" in this manual.
17
Lowe's Home Centers LLC.
Mooresville, NC 28117
Printed in China

Publicidad

loading

Este manual también es adecuado para:

38098984132850466501651296845192325