Publicidad
Idiomas disponibles
Idiomas disponibles
4. Base Stand Assembly Instructions
Parts
needed for base stand assembly
Rear cabinet of TV
TV stand
Screws:6 x M4 x 12 (supplied)
5. Remote Control Installing Batteries
1). Open the battery compartment cover on the back of the remote control.
2). Insert two 1.5V AAA size batteries observing the polarity markings inside the battery
compartment. Don't mix different types or used batteries with new ones.
3). Close the cover.
Batteries shall not be exposed to excessive heat such as direct sunlight or fire.
- The remote control should be operated within 23 feet (7m) and 30
IR receiver at the front of the TV.
- Used batteries should be disposed of properly
Step 1
Battery
Compartment
Cover
All manuals and user guides at all-guides.com
Installation
(Gently place the TV face down on a soft, flat surface, such as a blanket,
foam, or cloth.)
1. Put the stand on the TV set
2. Screw the stand in the positions with the screws supplied (6 x M4 x 12).
Step 2
2 x AAA Battery
Note: the pictures below are only for reference
0
to the left and right of the
Introduction
Screws: 6xM4x12
Step 3
9
Publicidad
