Bollhoff RIVQUICK B2000 Manual Del Usuario página 16

EXE RQ SERIE B V1:48 PAGES
5. Battery and charger
5.1. Technical Data
5.2. Battery charging
I
Charge only RIVQUICK
I
To have the charger connected to proper power supply, insert the battery onto the charger;
I
The RIVQUICK
the "Electronic Cell Protection, (ECP)".
It blinks in rotation
Light blinks green
Light steady green
Light steady red
Light blinks red
5.3. Safety instructions
I
The battery should be removed from the tool when the tool is stored or will not be used for a long
period of time;
I
Never try to charge a damaged battery;
I
Do not insert a dirty or wet battery into the charger;
I
Never throw batteries into the waste, into fire, into water;
I
Do not charge a battery when the environmental temperature is below 0°C or higher than 45°C.
5.4. Charger safety instructions
I
Make sure that the charger and its power connection equipment are not damaged;
I
Always use the genuine power connection equipment of this tool;
I
Never use the charger in a humid or wet environment, or close to inflammable substances or gases.
Failure to comply with this instruction might cause explosion.
Heruntergeladen von manualslib.de
28/04/14
Battery
Nominal voltage
Cell
Number of cells
Capacity
Weight
Charger
Input voltage
Output voltage
Output current
Weight
® B2000 / RIVQUICK
® B2000 / RIVQUICK ®
LED lights / Different status
Handbücher-Suchmachiene
18:12 Page 18
14,4 VDC
Li-ion
4
1,4 Ah
0,35 kgs
100–240 VAC / 50-60 Hz
14,4 VDC
1,5 A max.
0,47 kgs
® B3000 batteries supplied by authorized distributors;
B3000 Li-ion battery is protected against deep discharge by
Battery is empty The tool is switched off by means of a protective circuit.
During the process of charging
Battery is charged
The charging temperature out of range (0°C~45°C); and charging must be
terminated
Check the condition of the power plug, if still blinking red, it indicates the
battery is damaged, charging must be terminated
8
2,8 Ah
0,59 kgs
Meaning of the light signal