Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Unpacking the washing machine
Fig.4
1. Remove the cardboard box and styrofoam packing.
2. Lift the washer and remove the base packaging.Make sure the small triangle
foam (a) is removed with the bottom packaging together. If not, lay the unit down
on the side surface and remove it manually.
3. Remove the tape securing the power supply cord and drain hose.
4. Remove the inlet hose from the drum.
Remove transport bolts
WARNING:
• You must remove the transport bolts from the backside before using the product.
- Loosen the 4 transport bolts with a spanner. Fig. 5
- Remove the bolts including the rubber parts and keep them for future use. Fig. 6
- Close the holes using the cover caps. Fig. 7
Levelling the washing machine
WARNING:
• The lock nuts on all four feet must be screwed tightly against the housing.
Fig. 8
1. Loosen the lock nut.
2. Turn the foot until it reaches the floor.
3. Adjust the legs and lock the nuts with a spanner. Make sure the machine is level
and steady.
Connect the water supply hose
WARNING:
To prevent leakage or water damage, follow the instructions in this chapter
• Do not kink, crush or modify water inlet hose.
Connect the water supply hose to the water inlet valve and a water tap with cold
34
LAVADORA EVVO NOVA 8.6/10.7 X
Publicidad
