Dometic Tank Discharge Control
Caution!
Do not allow discharge pump to operate for an extended period of time when there is no
discharge from holding tank. Damage to pump may result.
7.2
OPTION 2: DTD01 discharge control panel with DTM04 tank monitor system
(fig .
6
6 , page 4)
1 . When the Dometic Tank Monitor panel reads "Full" (3) and boat is in unrestricted waters, insert key
into switch and turn to momentary "Start" position (1) .
2 . Allow key to rebound to "Pump On" position (2) . Green light indicates that pump is running .
3 . When pump-out is complete and Tank Monitor panel reads "Empty" (4), pump will automatically
shut off and green light will shut off . Turn key to "Off" position and remove key from switch any time
after pump-out is complete to secure pump .
Caution!
Operator must know local regulations for emptying a holding tank.
8
Warranty and Product Liability
Europe:
Warranty and Customer Service
Warranty arrangements are in accordance with EC Directive 44/1999/CE and the normal conditions
applicable for the country concerned . For warranty or other service, please contact our Dometic/
Waeco Service department listed elsewhere in this manual . Any damage due to improper use is not
covered by the warranty .
The warranty does not cover any modifications to the product or the use of non-original Dometic parts;
the warranty does not apply if the installation and operating instructions are not adhered to and no
liability shall be entertained .
Product Liability
Product liability of Dometic Group and its subsidiary companies does not include damages which
may arise from: faulty operation; improper alterations or intervention in the equipment; adverse
effects from the environment which may impact the equipment itself or the direct vicinity of the
equipment or persons in the area .
To obtain warranty service, first contact your local dealer from whom you purchased this product or go
to http://www .dometic .com for a dealer near you .
Warranty and Product Liability
9