Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
Control Panel
1) When first operating the dehumidifier, run it in Continuous mode for 24 hours.
2) Power On and Off- Press the POWER button once to manually turn the unit on.
Press the POWER button once more to turn the unit off.
3) Humidity Selection- Press the
humidity in the room.Each press of the button will change the desired room
humidity by 5%. The room humidity is selectable from 35%-80% or continuous.
The unit will cycle on and off to maintain the humidity level chosen on the digital
display. If you want the dehumidifier to operate continuously regardless of the
room humidity, press the MODE button until you see "CO" on the digital display.
This will enable continuous operation and the "Continuous" indicator will light up on the control panel.
4) Fan Speed Control- Press the FAN SPEED Button to cycle through the different fan speeds:
High, Medium, and Low. The fan speed can be visually distinguished by the fan speed indicators on the control panel.
5) Timer Auto On- To program the unit to automatically turn on, press the TIMER button when the unit is off. Press or to increase or decrease the timer in 30 min
increments (0.5 hours)up to 10 hours. After 10 hours, each press of the button will increase the timer in 1 hour increments up to 24 hours.
Timer Auto Shut-Off- To program the unit to automatically turn off, press the TIMER button when the unit is on.Each press of the or buttons will change the
timer setting in 30 min increments (0.5 hours) up to 10 hours. After 10 hours, each press of the or buttons will increase or decrease the timer in 1hour
increments up to 24 hours. Once the desired time is over, the unit will automatically power off. Once the desired time is reached-the unit will automatically turn on.
NOTE: Fan will continue to run even when the compressor is off. This is normal and allows the unit to circulate air and operate more efficiently.
6) Bucket Full- When the water bucket is full of water, the unit will automatically shut off, make a beeping noise, and the Bucket Full
Indicator will light up. The dehumidifier will not function until the water bucket is emptied and placed back inside the unit. The bucket
should be cleaned every few weeks to prevent the growth of mold, mildew and bacteria. Use a mild detergent to
clean the bucket. Once clean, completely dry the bucket and place it back inside the dehumidifier.
NOTE: Hold bucket with both hands when emptying.
NOTE: When the bucket is full or removed from the machine, the compressor will turn off, but the fan will
continue to run for a few minutes. This is completely normal.The dehumidifier will not be removing
moisture from the air at this time.
NOTE: When removing moisture from the air, the dehumidifier will exhaust warm air from theside exhaust vent.
NOTE: Do not place a full bucket on the floor, because the bottom is uneven.
or
buttons to choose the desired relative
6
2
3
1
4
5
Publicidad
