Descargar Imprimir esta página

Pearl CEP Serie Manual De Instalación Y Mantenimiento

Bombas de agua centrífugas

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Pearl
Water Systems
TO AVOID SERIOUS OR FATAL PERSONAL INJURY OR MAJOR
PROPERTY DAMAGE, READ AND FOLLOW ALL SAFETY
INSTRUCTIONS IN THIS MANUAL AND ON THE PUMP.
Before installation, you should carefully read
this manual, and pay attention to safety
cautions and instructions in this manual. Our
factory is not responsible or reliable for paying
compensation for personal injury, pump
damage, and other property losses caused by
violation of safety cautions.
1. GENERAL INFORMATION
1.1These pumps are used for household water supply,
equipment support, pipeline pressurization, garden watering,
vegetable greenhouse watering, fish farming and poultry
raising, industrial and mining, water supply and drainage for
enterprises and high-rise buildings, central air conditioner and
centralized heating circulation systems, etc.
1.2 These pumps are used to transfer clean water and other
non-corrosive liquids with low viscosity; do not transport
inflammable, explosive, gasified liquids and liquids containing
solid particles or fibers. The pH value should be within 6.5-8.5.
2. MODEL DESCRIPTION
CEP 05 A 1 6 S
Features S=Standard
Hertz 5=50hz, 6=60Hz
Phase 1=Single phase, 3=Three phase
Voltage A=115V, C=230V, F=110/220V
HPx10
Series Centrifugal Pump
3. TECHNICAL DATA
Max. Flow: 1800L/min
Max. Head: 75m
Output power: 0.25~11kW
Max. Suction: 8 m
Insulation grade: IP44
Protection grade: F
Max. ambient temperature: +40
Max. liquid temperature: +60
4. IMPLEMENTATION STANDARDS
IEC/EN 60335-1 Household and similar electrical appliances-
-safety Part1: General requirements.
IEC/EN 60335-2-41 Household and similar electrical
appliances--safety Part2-41: Particular requirements for the
pump. 2006/95/EC Low voltage directive
INSTALLATION AND OPERATING INSTRUCTIONS
5. SAFETY PRECAUTIONS
5.1 To ensure the normal and
safe operation of the electric
pump, read this manual
carefully before use.
5.3 Do not touch the electric
pump while it is working;
do not wash, swim near the
working area or let livestock
into the water to avoid
accidents.
CEP-C2P
centrifugal water pumps
M a n u a
ON
OFF
1 1
1 1
5.2 The electric pump should
0 0
0 0
have reliable grounding to
prevent a short circuit; it
should also be equipped with
a leakage protection switch
for safety. Be careful not
to wet the power plug; the
socket should be connected
in a damp-proof area.
5.4 Avoid splashing pressured
water into the electric pump.
Prevent the pump from being
immersed in water.
l

Publicidad

loading

Resumen de contenidos para Pearl CEP Serie

  • Página 1 Pearl CEP-C2P centrifugal water pumps Water Systems INSTALLATION AND OPERATING INSTRUCTIONS TO AVOID SERIOUS OR FATAL PERSONAL INJURY OR MAJOR PROPERTY DAMAGE, READ AND FOLLOW ALL SAFETY INSTRUCTIONS IN THIS MANUAL AND ON THE PUMP. Before installation, you should carefully read this manual, and pay attention to safety cautions and instructions in this manual.
  • Página 2 6. PRODUCT STRUCTURE 5.5 Keep the pump in a well- ventilated area. 5.6 In case the ambient temperature is lower than 4°C, or the pump is not used for a long time, empty the liquid from the pipeline system to avoid ice cracking of the pump chamber.
  • Página 3 NEGATIVE SUCTION INSTALLATION PRECAUTIONS FOR INLET PIPELINES 1. While installing the electric pump, do not use a rubber tube CORRECT INSTALLATION that is too soft for the inlet pipeline because it may collapse. 2. The foot valve should be vertically placed and installed 30cm 1.
  • Página 4 SINGLE PHASE CONNECTION 110V or 220V 9. START-UP MAINTENANCE Do not start up the pump before the pump chamber is filled with water. CAPACITOR Do not touch the electric pump unless its power has been cut off for, at least, 5 mins. Do not dismount the pump body unless the water in the pump chamber is emptied.
  • Página 5 10.TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION Single-phase power supply (three-phase electric a. repair switch contact or replace the switch; motor): b. replace the safety fuse; a. poor connection of the power switch; c. check and tighten the power connector; b. fuse is burned out. d.
  • Página 6 Pearl CEP-C2P bombas de agua centrífugas Water Systems MANUAL DE INSTALACIÓN Y MANTENIMIENTO Antes de la instalación, lea cuidadosamente este manual y ponga atención a las medidas de seguridad e instrucciones del mismo. Nuestra empresa no responde ni paga compensaciones por daños personales, daños a la bomba u otras pérdidas...
  • Página 7 6. PARTES 5.4 Se debe evitar lavar la electrobomba con agua a presión, así mismo, se debe prevenir que el equipo se inunde. 5.5 Mantenga la bomba en un lugar ventilado. 5.6 En caso de que la POS. PART temperatura ambiente esté por debajo de 4°C ó...
  • Página 8 SUCCIÓN NEGATIVA PRECAUCIONES DE INSTALACIÓN EN LA SUCCIÓN INSTALACIÓN CORRECTA 1. No use demasiado pegante de PVC o cinta teflón en las uniones roscadas, para evitar que los sobrantes obstruyan la 1. Válvula de pie 2. Tubería de succión tubería. 3.
  • Página 9 CONEXIÓN TRIFÁSICA 8.2 EN LO POSIBLE, EVITE QUE LA ELECTROBOMBA QUEDE MUY LEJOS DE LA FUENTE DE SUMINISTRO ELÉCTRICO. En la medida que esta fuente esté a mayor distancia de la bomba, el cable debe ser de mayor calibre, de lo contrario el voltaje se bajará...
  • Página 10 9.5 El registro debe estar totalmente cerrado antes de 3. En caso de que la electrobomba no se vaya a usar por arrancar la bomba. largo tiempo, vacíe el agua de la bomba, recubra el cuerpo de la bomba, el impulsor y el plato porta sello con aceite 9.6 Arranque la bomba.
  • Página 11 10. PROBLEMAS Y SOLUCIONES SíNTOMA CAUSA PROBABLE ACCIÓN CORRECTIVA No coincide el tipo de conexión interna de la bomba con el de la conexión a la red. (p. ej. se suministra energía Verificar las conexiones eléctricas monofásica a un motor trifásico). Fusibles quemados Remplazar fusibles EL MOTOR NO...

Este manual también es adecuado para:

C2p serieCep 05a16s