KitchenAid 5KGM Manual Del Propietário página 5

PRODUCT USAGE (CONTINUED)
USING THE GRAIN MILL ATTACHMENT
TIP: Note the grind symbols at the top of the dial. The Fine Grind symbol indicates the finest
grind setting. The Coarse Grind symbol indicates the setting for the grind that is most coarse.
Each notch on the dial represents a grind setting.
1.
Select the finest grind setting by turning the adjustment knob clockwise to the Fine Grind
symbol and immediately turn adjustment knob back 2 notches.
2.
Fill the hopper with grain.
3.
Once the grain is added, start the Stand Mixer at Speed 10.
NOTE: If the grind is too fine, turn the adjustment knob counterclockwise, one notch at a
time, until the desired setting is obtained.
4.
Continue to replenish grain in the hopper until the desired amount of grain is ground.
NOTE: Do not grind more than 1250 g of flour at one time, or damage to the Stand Mixer
may result. After grinding 1250 g of flour, allow the Stand Mixer to cool for 45 minutes
before using it again.
CARE AND CLEANING
CLEANING THE GRAIN MILL ATTACHMENT
IMPORTANT: Allow the appliance to cool completely before putting on or taking off parts, and
before cleaning the appliance.
1.
Clean the burrs and all other parts with the provided brush. The Grain Mill Attachment
does not necessarily need to be cleaned after every use, but should be brushed when
changing types of grains. If needed, a toothpick may be used to clean the burr grooves.
2.
If the Grain Mill Attachment must be washed, wash it by hand with mild detergent and
warm water. Dry the main body thoroughly with a towel. Allow the parts to air dry. Do not
reassemble until next use. If the burrs are not completely dry, grain may clog the Grain Mill
Attachment.
IMPORTANT: Do not wash the Grain Mill Attachment or any of its parts in an automatic
dishwasher.
If the Grain Mill Attachment is to be stored for a long period of time, lightly coat the burrs
with mineral oil. Before next use, hand wash as directed in the "Before first use" section to
remove the mineral oil.
ELECTRICAL EQUIPMENT WASTE DISPOSAL
DISPOSAL OF PACKING MATERIAL
The packing material is recyclable and is marked with the recycle symbol
of the packing must therefore be disposed of responsibly and in full compliance with local
authority regulations governing waste disposal.
RECYCLING THE PRODUCT
-
By ensuring this product is disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which could otherwise be caused by
inappropriate waste handling of this product.
For more detailed information about treatment, recovery and recycling of this product, please
contact your local city office, your household waste disposal service or the shop where you
purchased the product.
. The various parts
5