Publicidad
Idiomas disponibles
Idiomas disponibles
CHARGING PORTS AND CONNECTABLE DEVICES
Charging Port 1
Cyber-
Pack
Battery
(KAC804 KAC810) (KAC804 KAC810)
pack
Kress
60V bat-
tery
Robotic mower
(KR800)
Inverter
(use only invert-
ers specified by
Kress)
NOTE: For charging port 2 and charging port 3, when battery packs are
installed on both charging port 2 and charging port 3, the battery pack
installed first will get charged first. And when a robotic mower is connected to
charging port 3, the robotic mower will be charged first.
NOTE: It is also feasible to install battery packs first before turning on the
CyberTank. In this mode, The battery pack with more power level will be
charged first.
(See Fig. E)
FLASH CHARGING
When charging a battery pack in charging port 1; Press the flash charging
button for 3 seconds, the flash charging mode will start.
NOTE: Pressing the flash charging button again, for 3 seconds, will cancel the
flash charging mode.
In flash charging mode it will take 8 minutes to fully charge a CyberPack
battery.
E
CHARGING AND FLASH CHARGING
Charging Port 1
Charging
Flash charging
NOTE: Flash charging mode is only available on charging port 1.
NOTE: When the power level of the battery cabinet is less than 20 %, the
flash charging mode is unavailable.
NOTE: Only one charging port can be used for charging when the power
level of battery cabinet is less than 20 %.The battery pack installed first will
get charged first. When a robotic mower is connected to charging port 3, the
robotic mower will be charged first.
CHARGING THE BATTERY CABINET
Mode 1: AC cable charging
1.
Ensure the circuit breaker is turned on, and the emergency stop is off.
2. Connect the CyberTank to the outlet with the AC cable.
Charging Port 2
Charging Port 3
(KAC804)
Charging Port 2
Charging Port 3
3. Press the on/off button to turn on the CyberTank. (See Fig. D)
NOTE: When CyberTank is already turned on, connect it to the mains directly.
NOTE: When charging the battery cabinet and the battery packs at the same
time, battery packs will charge first and then the battery cabinet will charge
after the batteries have finished charging.
NOTE: Use grounded sockets.
Warning! Considering the current capacity, please use the
dedicated line to avoid overload of power supply.
NOTE:
An extension cord can be connected between the CyberTank and the
AC cable to extend the connection distance.
Mode 2: Solar power charging
Please seek help and guidance from the dealer.
NOTE: Connect the CyberTank with the Kress solar power inverter. The input
voltage is 48 V.
Mode 3: Power generator charging
Choose the generator that meets the technical data.
Read the power generator manual carefully before operating.
Please seek help and guidance from the dealer.
LED DISPLAY
The display shows the charging status and the power level of battery packs
and battery cabinet.
%
60
25
%
1
2
4 min
Different symbols on the display represent different operating status.
Symbol
Charging
Flash Charging
15:23
5 kWh
25
%
3
Status
EN
9
Publicidad
