Makita PC5000C Manual De Instrucciones página 8

To install the dust cover's brush, firstly align the both
ends of the brush with the groove of the dust cover.
And then insert the brush all the way into the groove of
the dust cover by using slotted driver or other appropri-
ate tool.
Dust bag
1
► 1. Dust bag
To install dust bag, slip onto dust port. Always make
sure to slip onto dust port all the way until it stops so
that it does not come off during operation.
Remove dust bag when it begins to touch cutting sur-
face. This is a sign that it is full. Failure to empty bag will
lead to poor suction/pickup.
Connecting a vacuum cleaner
When you wish to perform clean planing operation,
connect a Makita vacuum cleaner to your tool as shown
in the figure.
OPERATION
Planing in corners
For PC5000C
Flush planing of corners is possible after first removing
the dust cover cap.
For PC5001C only
4
► 1. Dust cover cap 2. The whole roller holder 3. Hex
socket head bolt 4. Hex bolt
Before performing the flush planing of corners, remove
the hex bolt which secures roller holder and base holder
and then take away the whole roller holder.
Next, loosen the hex socket head bolt and take away
the dust cover cap and then adjust the dust cover in a
proper position according to your work.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
• Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
8 ENGLISH
1
2
3