Publicidad
Idiomas disponibles
Idiomas disponibles
STI2006-2x3ML-v1p2
FCC Compliance (FCC ID: TDGVM200RF )
The equipment has been tested and found to comply with the limits for a
Class B Digital Device, pursuant to part 15 of the FCC Rules. These limits
are
designed
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction, may cause harmful interference to radio
communication. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment dose causes harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
The user should not modify or change this equipment without written
approval from Salient Technology. Modification could void authority to
use this equipment.
The changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
To comply with the FCC RF exposure compliance requirements, this
device and its antenna must not be co-located or operating to conjunction
with any other antenna or transmitter.
CE
This device complies with the essential requirements of the European
Council Directive listed below:
99/5/EC Radio & Telecommunication Terminal Equipment (R&TTE)
Directive
Art.3.1a) EN 60950
Art.3.1b) EN 301 489 -1/-3
Art.3.2) EN 300 440
to
provide
reasonable
4/97
protection
against
harmful
Publicidad
