Climadiff CLI45 Manual De Utilización página 23

•
You can choose the desired chamber temperature by using the "+ / -". buttons
increases/decreases by 1°C with each button press.
Temperatures of between 5 and 22°C can be selected. Once the desired temperature has been selected, the
display will flash before showing the current internal cooler temperature. The set temperature can be viewed
at any time by pressing the temperature select buttons
If the appliance runs after a power failure, the previous set temperature does also exist as the control panel
has the memory function.
5° EQUIPMENT
The climate control system
According to advice from specialists, the ideal temperature for storing wine is around 12°C, within a bracket of 10
to 14°C. Do not confuse this with service temperature, which varies between 5 and 22°C, depending on the
specific nature of the wine.
It is especially important to avoid sudden changes in temperature. Designed by specialists for oenophiles, this
appliance, unlike a simple refrigerator, takes into account the sensitivity of grand cru wines to sudden variations in
temperature by ensuring the close control of a constant average temperature.
The anti-vibration system:
The refrigeration compressor is equipped with special dampers (silent-blocks) and the inner space is insulated
from the body by a thick layer of polyurethane foam. These characteristics prevent the transmission of vibration to
your wines.
Defrosting:
Your appliance is equipped with an automatic defrost cycle. When a cooling cycle finishes, the appliance's
refrigerated surfaces are defrosted automatically. The defrost water is channelled into a condensates evaporation
tray which is located in the back of the appliance near the compressor. The heat produced by the compressor
then evaporates the condensates collected in the tray.
Shelves
•
To prevent damage to the door seal, ensure that the door is fully open before pulling out the shelves to add
or remove bottles.
•
For easier access to the contents of the shelves, slide the shelf out approximately one third of the way. The
shelves are, however, fitted with a stop to prevent the bottles falling out.
•
To remove or reposition the shelves, incline the shelf as indicated in the diagram, then push or pull as
required.
Enhanced safety:
Since this range of appliances is intended for storing items of value, we have been careful to select quality
components and to design suitable manufacturing techniques to ensure optimum safety in operation.
All manuals and user guides at all-guides.com
.
The temperature selected
23