Publicidad
Idiomas disponibles
Idiomas disponibles
• To stop blending at any time, press the
button.
• When blending hot ingredients, always let them cool at least 5 minutes
before blending. Begin blending on the lowest speed with the lid cap off
to allow steam to escape. Cover lid cap hole with towel or hot pad.
• When crushing ice with no other ingredients, use 2 cups ice max (about 15
cubes). Make sure blender jar is completely dry before ice crushing.
CA RE A N D C LEA N IN G
This product contains no user serviceable parts. Refer service to qualified
service personnel.
• Unplug the blender base before cleaning. Wipe the blender base using a
damp cloth. Do not immerse the blender base in water.
• Lift the blending jar, by the handle, off the base.
• Remove lid and lid cap.
• Wash removable parts by hand or in the dishwasher. Place the jar on the
bottom rack and the rest of the parts on the top rack only.
Caution: Blades are sharp. Handle with care when hand washing.
CL EA NI NG T IP S :
• For quick cleanup, combine 1 cup hot water and a drop of liquid dish soap
in the blending jar.
• Place lid with lid cap securely on jar and blend on speed 3 for about 30
seconds.
• Discard liquid and rinse thoroughly.
Important:
• Do not place the jar parts in boiling liquids.
• Do not immerse the base in liquid. Wipe the base with a damp cloth and
dry thoroughly.
• Remove stubborn spots by rubbing with a damp cloth and nonabrasive
cleaner.
Note: If liquids spill onto the base, wipe with a damp cloth and dry
thoroughly. Do not use rough scouring pads or cleansers on parts or finish.
TROU B LESHO OTIN G
Problem
All LEDs blinking
quickly
(100 msec/time)
Blender stops/
goes into
STANDBY mode
Blender is
having difficulty
blending
Possible Cause
Blender overheated or
button held longer
than 30 seconds.
Blending time exceeds
2.5 minutes.
Mixture is too thick or
air bubble has formed
between mixture & blade.
/
(pulse/stop) or
Solution
Unit must be reset. Unplug to
reset. Let unit cool for at least
20 minutes.
Re-select appropriate speed
setting to start blender.
Turn blender off. Use rubber spatula
to scrape down sides of jar and
redistribute, pushing food towards
blades. Add more liquid if needed.
19
(on/off)
Publicidad
